new handlebars
hey im lookin for some shorter handlebars, i was lookin into the S&M Dive bars, does ne one know if there good or know any better brands with a short bar, pref. 24"
|
If you want bars that aren't wide, then just cut your bars. I usually use a tube cutter from my local hardware store, but if you are careful you can use a hacksaw. Just make sure to file any rough edges when you are done and don't cut off more than an inch from either end at a time so you can figure out what width you like best. It's easy to take off bar from the ends... a lot tougher to put it back on.
|
thanks a lot man
|
All times are GMT -6. The time now is 05:13 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.