Attention Scooper: Stainless Steel frame porn
#1
Senior Member
Thread Starter
Join Date: Jul 2006
Location: San Jose (Willow Glen) Ca
Posts: 9,845
Bikes: Kirk Custom JK Special, '84 Team Miyata,(dura ace old school) 80?? SR Semi-Pro 600 Arabesque
Mentioned: 106 Post(s)
Tagged: 0 Thread(s)
Quoted: 2338 Post(s)
Liked 2,822 Times
in
1,541 Posts
Attention Scooper: Stainless Steel frame porn
__________________
Life is too short not to ride the best bike you have, as much as you can
(looking for Torpado Super light frame/fork or for Raleigh International frame fork 58cm)
Life is too short not to ride the best bike you have, as much as you can
(looking for Torpado Super light frame/fork or for Raleigh International frame fork 58cm)
#3
Decrepit Member
Dave is one of my favorite builders. He said a couple of months ago that he would be building in stainless now that stays were available in the dimensions and wall thickness he was looking for. That bike is gorgeous.
#4
Decrepit Member
Dave Anderson is another of my favorite builders. He's been building in stainless for several years.
#6
Senior Member
Join Date: Dec 2012
Location: St. Paul, MN
Posts: 1,597
Bikes: Too many 3-speeds, Jones Plus LWB
Mentioned: 12 Post(s)
Tagged: 0 Thread(s)
Quoted: 359 Post(s)
Liked 265 Times
in
119 Posts
Dave Anderson built my frame- custom setup complete with 953 fork Newvex lugs and Rohloff dropouts. I probably missed a bet not going with disk brakes but even with the Rohloff it comes in around 21 pounds.
#8
Senior Member
Join Date: Dec 2012
Location: St. Paul, MN
Posts: 1,597
Bikes: Too many 3-speeds, Jones Plus LWB
Mentioned: 12 Post(s)
Tagged: 0 Thread(s)
Quoted: 359 Post(s)
Liked 265 Times
in
119 Posts
The bike uses early Paramount touring geometry with easy clearance for a 28mm 700c clinchers with rim calipers. I can fit fenders if needed. Braze-ons are used to route the cables for the Rolhoff hub- adjusters mounted on the left side chain stay. The dropouts are Rolhoff, which allow for adjustment of the chain (no chain tensioner). A fairly wide Phil Wood BB spindle is used to obtain the correct chain line with a Velo Orange Grand Cru track crank. I used that for the 165mm length as that favors spinning. I'm still experimenting with the handlebars and where to put the shift for the Rohloff. The chainwheel is a place-keeper for now (I need 42 teeth with a 110 BCD for the Grand Cru crank); if I keep it, it will be a candidate for Drillium.
The gears are such that I can still use high going downhill, with enough on the low end that I can really spin going up steep stuff. The hardest hill in the Twin Cities is the Ramsey Hill and I can climb that in 3rd 'easily' enough. The bike is meant to be a good all-rounder, with relaxed geometry for commuting, touring and longer distance races (the Dairyland Dare comes to mind).
Last edited by Salubrious; 03-17-15 at 12:35 PM.