Help with new Controller
#1
Newbie
Thread Starter
Join Date: Feb 2016
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Help with new Controller
Hey all I bought a Busetti bike last year and it worked for a bit and then basically started getting short little bursts of power but would not run correctly. After going through everything on the bike I finally decided the controller was probably bad so I bought a new one. The new one is different from the old one, but I was able to match some of the labels, and some of the colors to where I think I wired it in correctly. It wont turn on, however, and I can't get any power to the display or throttle at all. Any ideas?
Thanks!
Dan
Thanks!
Dan
#2
Senior Member
Join Date: Jul 2014
Location: socal
Posts: 4,252
Mentioned: 9 Post(s)
Tagged: 0 Thread(s)
Quoted: 878 Post(s)
Liked 812 Times
in
613 Posts
Sounds like the nightmare Rick went through. AIR, there are 120 possible combinations for the sensors. Might try endless sphere with photographs of the wiring.
#3
Senior Member
Join Date: Mar 2015
Location: gold coast australia
Posts: 102
Bikes: repco MTB 26" + sram 2 speed automatix hub , road king cruiser 26" + lifepo4 48v x 12ah + 200w motor
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Personally ,, i found that my cheapie unit from my fun cruiser did the job ,,,"heaven knows why)