gr84l

I have developed shoulder pain in the front of my R shoulder since I began to ride a road bike last July. I've ridden about 1800 miles since then. The pain is over the anterior tendon to my biceps muscle. I have a hunch that it might be due to how wide my handlebars are; 46 cm. I should be using 42 cm. Has anyone over heard of wide handlebars causing shoulder pain?

stapfam

Waiting for the answer now.

I ride an MTB with 27" riser bars- In Fact I ride two as the Tadem also has wide bars. On an MTB-Wide bars will give you control once you get used to them and I am currently riding 42's on the road bike. I am quite small but I do feel that a wider bar would give me more bike control.

HAMMER MAN

no, i have not,but does not mean it dosen't happen

i use 44 on both bikes and no problems,you might want to check your fore/aft position as well as the tilt of your saddle you could be too bunched up or too stretched out; and check the height also too make sure you are getting the proper leg extension.
imo all of these can contribute to shoulder pain.

bobbycorno

It might be the height of your bar, not the width. How does the height of your bar compare to your saddle? Too much drop (to the bar) could be putting excessive pressure on your arms and shoulders.

Scott P
Bend, OR

Tom Bombadil

Haven't seen any studies, but I have been told by two bike fitters that it can lead to shoulder pain.

Here's a web page that claims the same:
https://www.roadcycling.com/cgi-bin/a...iew.cgi/6/1026

stapfam

Great article Tom and put on my favourites to fully digest later.

soma5

I use 42s and those are a little wide by usual standards for me but I don't have a problem. However, I would guess the answer to your question would be, "Yes, it could cause pain" especially if your bars are too wide AND you put a lot of weight on your hands AND you ride on the hoods or the drops. Wide bars effectively increase the extension, so that may also be an issue here. I would try to find an expert fitter in your area.

-soma5

europa

I ride 46cm wide bars and they are GREAT.

But that's my weird, stuffed up body.

I've heard the 'too wide gives shoulder pain' theory before but seeing it always came with advice about sticking the bars down near the axle to be 'aero' (the most over rated bit of advice on roadie forums), I haven't given it much credence. That doesn't mean it can't. All you can do it suck it and see (ie, bung narrow bars on her and see how it goes).

Richard

jim p

Thanks Tom for the article. I have the rubbery knots mentioned in the article and they are pure misery. I think my problem was caused by the bars being too low. Now I have to find out how to get rid of the knots. My bars were not too wide but my thinking is that if you are riding over 40 miles a week that you need to take care of any problems with fit or be prepared to put up with great misery like me. I have corrected my fit problem and after 4 months of the correct fit the knots are getting better but they are still there and let me know it when I try to move my arm.

solveg

Here's the salient sentence from Tom's article: Handlebars that are too wide may cause excessive trapezius and rhomboid strain leading to muscle spasm and pain. (Burke)

I'm too lazy to look up what those things are.

But, I should have 42 cm bars according to my FIT session, but I was initially hooked on 46cm bars from when I bought my Atlantis, and the LBS guys said they were better wide. I assume it was some Rivendell philosophy.

As I rode, I began to want narrower bars. I never "hurt", but I think I felt more fatigue. I don't ride on the flats very often, though. If you do, I don't see why it would make much of a difference.

Anyway, I'm getting rid of my 46cm bars slowly.

BluesDawg

Pain on a bike can be caused by pretty much anything in a given situation. What causes me pain may be the cure for yours, and vice-versa. My 46 cm Noodle bars feel great to me even though traditional rules would have me using 42s. That doesn't mean they couldn't be what is causing your pain. You just have to try different things.

And where I ride MTBs, 27" handlebars would lead to being wedged between two trees or to being slammed to the ground when one hand hits a tree and spins the bike to that side.

jppe

I had similar issues but my pain was caused by the reach being too long. It might not be what's causing your pain but just something you might check. A rule of thumb is when your hands are on the hoods the bars should block your view of the front hub when you look down at the front wheel. In my case the bar appeared to be in front of the hub. I rode with my arms stretched out, elbows "locked" and my shoulders absorbed all the road buzz.

Tom Bombadil

Would you consider something like this to be too wide or long?

The Smokester

How did you accomplish this... By shrinking them with withering looks?

Tom Bombadil

Maybe she's chewing on them as she rides.

solveg

Vanishing cream.

oilman_15106

The wider is better bar theory came from pro racing and some study(recently disproven) that you would get better oxygen intake if you were not keeping your shoulders inboard so much. My 1983 Centurion 50cm frame came with 38 width bars!

Can you get pain from the "wrong" width bars? I would say it is possible. Trip to a good LBS to talk about this issue might be in order. What else are you going to do, it is 15f with the wind chill.

countersTrike

like these (ram horn I found on Ebay):

countersTrike

countersTrike

BAH! Didn't work. Link:
https://cgi.ebay.com/Rams-Horn-Handle...QQcmdZViewItem

countersTrikes counterstrike

TruF