How to remove a brazed on cable stop.
 

I'm changing the setup on a frame I acquired recently, and would like to remove this rear derailleur cable stop.

http://bikeforums.net/attachment.php...hmentid=337624

Will a standard propane torch produce enough heat to melt the brass without damaging the chain stay, or should I just get out the hacksaw & grinder (and file and emery cloth)?

Thanks.

maybe add oxygen-propane torch .. whats wrong with it? you just need a stepped ferrule cable housing end.. to use it..

I'm going to use a Shimano 600 group on this bike, and the front derailleur has a built-in cable stop, so I have a clamp-on cable stop/guide for the down tube, which means the rear derailleur cable has to run on top of the chainstay. I have another clamp-on cable stop to replace the braze-on that I want to remove.

Is the oxy-propane readily available at hardware/building supply stores?

I just poked around on the webs & an oxy/propane set-up is more than I want to get into, so I think I'll go with the elbow grease method, old-style.

Thanks.

Shuncle -

Might want to hit a home store and look for a MAPP kit in the plumbing section.

Here is a start if its a Home Depot: Bernzomatic Model # 331673 OX220KC Oxy/Map-Pro Torch Kit

http://bikeforums.net/attachment.php...hmentid=337823

/K

Just cut it off and file it smooth very carefully to avoid cutting into the stay. No reason to introduce heat where its not needed. Those Bernzomatic torches are more trouble than they're worth. I went that route and burned through a lot of $10 oxy bottles just building one frame. It really sucks when the oxy runs out in the middle of a joint and the straight mapp soots up the joint, requiring you to clean it and start over.

Keep the flame on the stop itself, avoiding the stay as much as possible. When the braze under the stop melts, knock the stop off the stay. While the braze is still liquid, use a wire brush to brush the bulk of it off the stay and you'll have minimal clean up afterward.

N.B. Air/propane is unlikely to be hot enough to melt the braze. If you don't have a fuel/oxygen setup, use the saw and file method to remove the stop.

To use Oxygen/Propane or MAPP there is is a separate bottled gas purchase needed

.. check a welder's supply..

Thanks for all the advice.

I've been waffling over what to do with this frame ever since I got it, and I thought I had arrived at a final solution with removing this stop and adding the clamp-on stops to accommodate the Shimano 600 group.

Then I got a price from a local frame builder to move the rear stop to the top of the chainstay and add another one for the FD to the down tube - $50 - so that's what I'm going to do. Much cleaner look.

Thanks again.