Put on the Thomson?
#1
Senior Member
Thread Starter
Join Date: Jul 2004
Location: Orlando
Posts: 58
Bikes: Trek 5500
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Put on the Thomson?
Question: Assuming a saddle can be placed in the exact same fore-aft position – using the rails – is there any particular pro or con for using a set-back post vs a zero setback post? Everything on my bike is carbon, but my son gave me a Thomson Elite which looks soooooooooo good. My current post is a middle of the road carbon post with a 5mm setback, so I’m certain the Thomson could be put in the same position. As a biker who is not going to be placing a great deal of strain on any bike part, I know I wouldn’t see any difference in performance. Just hate to let the Thomson sit in my gear chest. Also, would inserting a metal post into a carbon tube be of any concern?
#4
59'er
Join Date: Oct 2005
Location: Alexandria, IN
Posts: 3,307
Bikes: LeMond Maillot Jaune, Vintage Trek 520 (1985), 1976 Schwinn Voyageur 2, Miyata 1000 (1985)
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 7 Times
in
3 Posts
Sounds like the Thompson would be a great upgrade. I personally prefer an aluminum seatpost over a carbon.
__________________
#5
Senior Member
Join Date: Aug 2004
Location: California
Posts: 567
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Liked 0 Times
in
0 Posts
remember that once you grease up your AL post and install it, it would be hard to clean out the grease to go back to carbon.
#6
Semper Fidelis
Join Date: Apr 2006
Posts: 3,000
Bikes: Tiemeyer Road Bike & Ridley Domicles
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 36 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
check out my thread from this morning concerning set-back and 0 setback and the problem I am having on the Road cycling forum
#7
Chairman of the Bored
Join Date: May 2004
Location: St. Petersburg, FL
Posts: 5,825
Bikes: 2004 Raleigh Talus, 2001 Motobecane Vent Noir (Custom build for heavy riders)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
If your current seatpost has a clamp that is not centered on the shaft of the seatpost (think Kalloy for a good example), get the setback.
If your current seatpost has a clamp centered over the shaft of the seatpost, then get the non-setback.
There you go!
If your current seatpost has a clamp centered over the shaft of the seatpost, then get the non-setback.
There you go!