Air pressure - problem if over inflate mtb tires?
I just put some Kenda 26x2.1 tires on my mtb, the knobbies were wearing out. These have tread, but smoother for the road.
On the side of the tire it says max pressure 40psi. That seems low to me, the tires I took off had a max of 65psi. I rode the bike with 42psi in them and they seemed ok, but just a touch mushy.
If I inflate to 50 or 60 (and the tire doesn't pop :eek: ) would this damage tire or make it wear out faster?
Good quality modern tires and good quality modern rims have a "hook bead" interface that makes it possible to use relatively high air pressure without blowing the tire off of the rim. Few people have the expertise to tell by looking if their tires and rims have this design. Frankly, 40psi sounds like a pre-hook bead specification to me.
Now I have no way of knowing why Kenda thinks that 40psi is the right maximum pressure to recommend on the sidewall. They might be being conservative in the event that somebody would install, and subsequently blow off, the tire from a non-hook-bead rim. They might have had a frequency of customers blowing tires off of their rims and successfully sueing Kenda. I'm not in a position to know. I doubt many other posters will have that kind of inside knowledge either.
What I do know is that if you exceed their maximum inflation recommendation you might be all right, but you will certainly be on your own.
|All times are GMT -6. The time now is 08:03 PM.|