Convert Hybrid to Road bike
#1
Junior Member
Thread Starter
Join Date: Jan 2010
Posts: 9
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Convert Hybrid to Road bike
I have 2009 Raleigh Cadent FT1 bike and planning to convert it to road bike.I had a Shimano ST-2203 3x8spd shifter/brake bought it from my friend w/o cable and a 42cm 31.8mm road dropbar bought from ebay.Can i change the mountain brake caliper to road bike caliper which fit to my bike.Any idea or suggestion what brake caliper is the best ?
#2
.
Join Date: May 2006
Location: Hillsboro, Oregon
Posts: 3,981
Bikes: Specialized Roubaix Comp, Soma ES
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Should work fine. From the pictures of the bike, it looks like it has v-brakes on it. Those will work fine with STI shifters like you bought. Those brake calipers should have good stopping power so no need to replace them if you don't have to spend the money.
__________________
Demented internet tail wagging imbicile.
Demented internet tail wagging imbicile.
#3
Junior Member
Thread Starter
Join Date: Jan 2010
Posts: 9
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
thank you knobster..but in the future if i want to change it,what road brake caliper should i use ? Because i'm afraid it will not fit on my bike if i buy a wrong road brake caliper later
#4
Junior Member
Thread Starter
Join Date: Jan 2010
Posts: 9
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
i think my bike is similiar with 2009 Raleigh Grand Sport https://www.raleighusa.com/bikes/road/2009-road/grand-sport/?page=overview the only diffrence (i think) is handlebar,crankset and brake/shifter.Can i follow this setup ?
#5
.
Join Date: May 2006
Location: Hillsboro, Oregon
Posts: 3,981
Bikes: Specialized Roubaix Comp, Soma ES
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Possibly. They are different bikes and use different components. Your bike has studs on the fork for the brakes where the Grand Sport only has a hole for the caliper. You probably have the same hole, but then you'd have two empty studs on the fork. The back should have a brake bridge on your bike, but again, you're using studs for the brakes on your bike since you have v-brakes. It may very well work but I doubt I would go that route. I converted an old mountain bike with cantilever brakes and 26" wheels to 700c wheels and caliper brakes. If I could do that with my bike, you can definitely do it with yours.
__________________
Demented internet tail wagging imbicile.
Demented internet tail wagging imbicile.
#6
Guest
Join Date: Jul 2008
Location: Grid Reference, SK
Posts: 3,768
Bikes: I never learned to ride a bike. It is my deepest shame.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 6 Times
in
6 Posts
Fromt he picture on the website, the bike has standard V-brakes, although the component list suggests they are "mini-V" brakes. Mini Vs should work fine, but standard length Vs will not. You might be able to set them up so they stop the bike, but they will be a pain to adjust and probably feel mushy as hell, and possibly constantly rub due to lack of clearance. Road bike brake levers are designed to pull less cable than is necessary to properly operate standard V-brakes.
Also the STI road levers probably won't work well with the Shimano Altus front derailleur - you need a road derailleur to work properly with road shifters.
You can possibly mount road caliper brakes on it, but Vs or properly set up cantilevers have more stopping power than calipers.
Also the STI road levers probably won't work well with the Shimano Altus front derailleur - you need a road derailleur to work properly with road shifters.
You can possibly mount road caliper brakes on it, but Vs or properly set up cantilevers have more stopping power than calipers.
#7
Junior Member
Thread Starter
Join Date: Jan 2010
Posts: 9
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
What kind of front derailleur should i use ? Still waiting for the brifter and dropbar(take quite long time to receive the items nearlly 3weeks ).
Last edited by azlan; 01-18-10 at 08:22 PM.
#9
Senior Member
Join Date: Feb 2008
Location: UK
Posts: 2,324
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 3 Times
in
3 Posts
From experience (I converted a Specialized Globe Sport Disc) I would just sell the bike and buy a road bike. I have had quite a bit of trouble and the fit has never felt 100%, I think I am getting close now but it has taken quite a bit of time!
#10
Alfredo Contador
Join Date: Jan 2010
Location: Where everybody knows my name
Posts: 431
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Similar experience to the guy I am referring to at the Hybrid section where he converted his trek 7.5fx with road bars. I think it was quite well done. However he sold it and got a CX road bike instead.
#11
Senior Member
Join Date: Feb 2004
Location: St Peters, Missouri
Posts: 30,225
Bikes: Catrike 559 I own some others but they don't get ridden very much.
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 1572 Post(s)
Liked 643 Times
in
364 Posts
Fromt he picture on the website, the bike has standard V-brakes, although the component list suggests they are "mini-V" brakes. Mini Vs should work fine, but standard length Vs will not. You might be able to set them up so they stop the bike, but they will be a pain to adjust and probably feel mushy as hell, and possibly constantly rub due to lack of clearance. Road bike brake levers are designed to pull less cable than is necessary to properly operate standard V-brakes.
Most folks report that STI's don't work well with mountain front derailleurs. If your bike has top tube cable routing, that's a whole additional issue to solve.
Honestly, when you start adding up the cost of converting to dropped handlebars, buying a whole new road bike starts to look cost effective to me.
#12
CAT4
Join Date: Jun 2007
Location: Omaha, Nebraska
Posts: 1,681
Bikes: 2009 Cervélo S1, 2009 Felt F75, 2010 Cannondale Synapse Carbon 5, 2011 Cannondale CAADx, 2011 Specialized Transition Elite
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
This advice is golden. Do you think after the conversion that your 2009 Raleigh Cadent FT1 is going to weigh the same as or have as nice of components as a road bike that costs as much as your bike plus conversion costs? I will answer it for you. NO.
#13
Senior Member
Join Date: Feb 2008
Location: UK
Posts: 2,324
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 3 Times
in
3 Posts
My build is here: https://www.bikeforums.net/bicycle-mechanics/513356-completed-flat-drop-conversion.html after many fit issues I shortened the stem and now it is feeling better. I don't like the bar ends so am now going with some campy levers and a shiftmate - this will also probably require travel agents for the brakes. However for me to get what I wanted in a road bike it would cost me at least £1100 this bike hasn't cost that yet. I think this will be the last thing I do to it though - I start work soon so that will be able to fund another bike which I will probably buy near the end of the year and it'll be exactly what I want! That'll be the last for a while (I know I know I say that now...!).
If you want some mechanical experience then by all means go ahead, I learnt a lot from doing it. If it is too much hassle for you to sell this bike and buy a new one, then go for it (both of these were my reasons for doing it).
But bottom line is don't expect it to feel like a road bike, my road bike feels very different but I still enjoy riding both.
If you want some mechanical experience then by all means go ahead, I learnt a lot from doing it. If it is too much hassle for you to sell this bike and buy a new one, then go for it (both of these were my reasons for doing it).
But bottom line is don't expect it to feel like a road bike, my road bike feels very different but I still enjoy riding both.
#14
Gear Hub fan
Join Date: Nov 2008
Location: Reno, NV
Posts: 2,829
Bikes: Civia Hyland Rohloff, Swobo Dixon, Colnago, Univega
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
I agree with daven1986 as road bikes and hybrids typically use quite different frame geometry. You can change to drop bars and brifters but it will never feel like a road bike. Most hybrids have overall geometry closer to that of older drop bar touring bike frames which means designed for comfort and stability even when carrying a load while a road frame is designed for fast handling and manuverability.
Amazing how small changes in frame angles and wheelbase can change the feel of a bike. Normally a conversion such as you want to do is more due to rider preference in riding position and handlebar type but the result will never really feel like a proper road bike would.
Amazing how small changes in frame angles and wheelbase can change the feel of a bike. Normally a conversion such as you want to do is more due to rider preference in riding position and handlebar type but the result will never really feel like a proper road bike would.
__________________
Gear Hubs Owned: Rohloff disc brake, SRAM iM9 disc brake, SRAM P5 freewheel, Sachs Torpedo 3 speed freewheel, NuVinci CVT, Shimano Alfine SG S-501, Sturmey Archer S5-2 Alloy. Other: 83 Colnago Super Record, Univega Via De Oro
Visit and join the Yahoo Geared Hub Bikes group for support and links.
https://groups.yahoo.com/group/Geared_hub_bikes/
Gear Hubs Owned: Rohloff disc brake, SRAM iM9 disc brake, SRAM P5 freewheel, Sachs Torpedo 3 speed freewheel, NuVinci CVT, Shimano Alfine SG S-501, Sturmey Archer S5-2 Alloy. Other: 83 Colnago Super Record, Univega Via De Oro
Visit and join the Yahoo Geared Hub Bikes group for support and links.
https://groups.yahoo.com/group/Geared_hub_bikes/
#15
Senior Member
Join Date: Feb 2008
Location: UK
Posts: 2,324
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 3 Times
in
3 Posts
Yep tatfiend is right, the geometries are different. However I will always keep this bike as something to carry larger loads (I have a rack on it). Like I said though, do it for the right reasons not because you want a road bike.