Ergon bar end on cannondale
#1
Junior Member
Thread Starter
Join Date: Sep 2013
Posts: 5
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Ergon bar end on cannondale
Has anyone installed an ergon bar end on a cannondale CX-3?
Ergon requires a 22.5mm diameter bar, CX-3 has a 25mm. I'm guessing it wont be a problem.
Thanks
Ergon requires a 22.5mm diameter bar, CX-3 has a 25mm. I'm guessing it wont be a problem.
Thanks
#2
Banned
they go on the end of the handlebar it has to be 7/8" that is 22.2 mm ,
even powdercoated 7/8" bars at 22.5 mm it gets to be a tight fit
no I dont own your same bike..
where do you pull the 25mm number out of ? thats like the center bulge not the ends of an MTB bar..
your measurement accuracy can be questioned, perhaps?
even powdercoated 7/8" bars at 22.5 mm it gets to be a tight fit
no I dont own your same bike..
where do you pull the 25mm number out of ? thats like the center bulge not the ends of an MTB bar..
your measurement accuracy can be questioned, perhaps?
#4
Banned
show me.
you even own the bike ?, and you cannot measure your own stuff?
put different handle bars in if you are willing or pay the shop to do it for you if its too hard.
Dude guess you cannot even read? 25mm is the rise offset not the diameter ..
Quote:
HANDLEBAR : CANNONDALE C4, 6061, 25MM RISE, 620MM (thats overall width)
you even own the bike ?, and you cannot measure your own stuff?
put different handle bars in if you are willing or pay the shop to do it for you if its too hard.
Dude guess you cannot even read? 25mm is the rise offset not the diameter ..
Quote:
HANDLEBAR : CANNONDALE C4, 6061, 25MM RISE, 620MM (thats overall width)
Last edited by fietsbob; 09-16-13 at 12:41 AM.
#5
Senior Member
Join Date: Jun 2013
Location: Coastal Maine
Posts: 109
Bikes: 2012 Marin Rock Springs, 2012 Trek 8.3 DS, 2013 Cannondale Quick SL2
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Standard bar ends will fit your Cannondale. All brands pretty much use the same dimensions.
After nearly 29,000 posts, "fietsbob" apparently has no life outside the internet and can't answer a simple question.
After nearly 29,000 posts, "fietsbob" apparently has no life outside the internet and can't answer a simple question.
#7
Senior Member
He has a point. aren't most handlebars 7/8?
__________________
Comedian Bill Hicks once said, "Money can't buy happiness, but it can buy a jet ski, and you never see an unhappy person riding a jet ski."
Comedian Bill Hicks once said, "Money can't buy happiness, but it can buy a jet ski, and you never see an unhappy person riding a jet ski."
Thread
Thread Starter
Forum
Replies
Last Post
redbird2
Bicycle Mechanics
4
03-09-14 02:26 PM