Ergon bar end on cannondale
Has anyone installed an ergon bar end on a cannondale CX-3?
Ergon requires a 22.5mm diameter bar, CX-3 has a 25mm. I'm guessing it wont be a problem.
they go on the end of the handlebar it has to be 7/8" that is 22.2 mm ,
even powdercoated 7/8" bars at 22.5 mm it gets to be a tight fit
no I dont own your same bike..
where do you pull the 25mm number out of ? thats like the center bulge not the ends of an MTB bar..
your measurement accuracy can be questioned, perhaps?
25mm was from cannondale's web site.
you even own the bike ?, and you cannot measure your own stuff?
put different handle bars in if you are willing or pay the shop to do it for you if its too hard.
Dude guess you cannot even read? 25mm is the rise offset not the diameter ..
HANDLEBAR : CANNONDALE C4, 6061, 25MM RISE, 620MM (thats overall width)
Last edited by fietsbob; 09-16-13 at 12:41 AM.
Standard bar ends will fit your Cannondale. All brands pretty much use the same dimensions.
After nearly 29,000 posts, "fietsbob" apparently has no life outside the internet and can't answer a simple question.
so i made a mistake reading the speck...new to bikes and this forum.....thanks for being SUCH A JERK!
He has a point. aren't most handlebars 7/8?