FSA Headset allen bolt torque
#1
Junior Member
Thread Starter
Join Date: Jun 2016
Posts: 23
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
FSA Headset allen bolt torque
Hey guys, so I'm fixing up a Norco 125 for my gf to ride around on.
I had to install a new stem and bars and while i was there i figured I would clean and regrease the headset. The headset as per norco is:
1 1/8" integrated FSA TH-855
My question now is, what would I tighten the luck nut/allen and what would be a safe torque spec?
I don't want to go full crazy and tighten it too much without damaging the bearings and headset.
This is the allen bolt i am referencing.
https://imgur.com/9nNJiuu
Thanks!
I had to install a new stem and bars and while i was there i figured I would clean and regrease the headset. The headset as per norco is:
1 1/8" integrated FSA TH-855
My question now is, what would I tighten the luck nut/allen and what would be a safe torque spec?
I don't want to go full crazy and tighten it too much without damaging the bearings and headset.
This is the allen bolt i am referencing.
https://imgur.com/9nNJiuu
Thanks!