Rear mech troubles
#1
Newbie
Thread Starter
Join Date: May 2005
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Rear mech troubles
Hi there folks,
I am having prolems with my XTR rear mech, when I am in 1st or 2nd and on the middle ring or the granny, the jockey wheel on the rear mech is touching the cogs on the block causing the chain to not run smoothly. I have adjusted the tension screw on the back of the mech to the max, this has helped, but still not enough to give clearance. Any body else out there had similar problems and fixed it? If so how?? Any clues are welcome, Thanks.
I am having prolems with my XTR rear mech, when I am in 1st or 2nd and on the middle ring or the granny, the jockey wheel on the rear mech is touching the cogs on the block causing the chain to not run smoothly. I have adjusted the tension screw on the back of the mech to the max, this has helped, but still not enough to give clearance. Any body else out there had similar problems and fixed it? If so how?? Any clues are welcome, Thanks.
#3
Newbie
Thread Starter
Join Date: May 2005
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Thanks, had thoiugh about this, but I think it will come off the stop which its tightening against (due to the screw being straight and the adjustment operating on a radius ......hope that makes sense).
#4
Keep Right Except to Pass
Join Date: Apr 2005
Location: Rainy Washington State
Posts: 166
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Ha, I am now running into this with a bike I just put together.
I'm using a 32T max cog and a long cage Deore derailleur. I've adjusted it to a point where the end of the screw is just barely catching the stop.
I'm still getting some noise but it's tolerable for now.
What is the solution? I know some people run a 34T so there must be something I'm missing.
Cheers
I'm using a 32T max cog and a long cage Deore derailleur. I've adjusted it to a point where the end of the screw is just barely catching the stop.
I'm still getting some noise but it's tolerable for now.
What is the solution? I know some people run a 34T so there must be something I'm missing.
Cheers