Bottom bracket tool...
#1
Senior Member
Thread Starter
Bottom bracket tool...
does a shimano bottom bracket tool also work with raceface or are they different?
#3
Senior Member
Thread Starter
The ones I've used/seen do. I've never personally put in anything other than shimano though so I can't be sure. I noticed that there is a specific Raceface BB tool. I'm not sure if they have the same number of splines or if the spacing is the same. I'm getting some new RF cranks and BB and am hoping they are the same.
#4
Throw the stick!!!!
The Park BBT-2 works with shimano square taper bb's, octalink bb's and ISIS bb's.
__________________
I may be fat but I'm slow enough to make up for it.
#5
Moar cowbell
Join Date: Oct 2004
Location: The 509
Posts: 12,481
Bikes: Bike list is not a resume. Nobody cares.
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 29 Post(s)
Likes: 0
Liked 6 Times
in
5 Posts
An ISIS BB tool should work on everything; but an older square-taper tool may not, because of the diameter of the ISIS BB spindle.
__________________
RST Suspension | Canfield Bikes | 7iDP Protection | Maxxis | Renthal | Hayes | VonZipper Optics | GoPro
Originally Posted by Mark Twain
"Don't argue with stupid people; they will drag you down to their level and then beat you with experience."
#8
Senior Member
Join Date: Sep 2005
Location: Monterey, CA
Posts: 247
Bikes: Stumpjumper FSR 30th Anniversary
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Originally Posted by dminor
An ISIS BB tool should work on everything; but an older square-taper tool may not, because of the diameter of the ISIS BB spindle.
1) the standard cartridge-type BB tool - has a crap-ton of little teeth and is about 1" in diameter. Example: Park BBT-2
2) the standard external bearing BB tool - a wrench-like contraption that has I think 16 teeth ...the hole in the center is just about 2" in diameter. Example: Park BBT-9
3) the tool for ISIS (or similar) BBs that have notches around the outside ring for the tool to fit around - then use a wrench on this interface tool to remove/install the BB. This is for one type of XTR BB and also Truvativ ISIS BBs. Example: Park BBT-8
My point is, if you have a Truvativ ISIS BB, you will need something like a BBT-8 (I found out the hard way). If you have any other type of ISIS or most recent square-taper cartridge BBs, a tool like the BBT-2 should work just fine.