14mm x 135mm rear hub
#2
Senior Member
Join Date: Dec 2008
Location: Under the Downunder
Posts: 1,014
Bikes: MTBs, BMX, Pocket MTB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Why a 14mm axle? Is it for a BMX or an MTB?
At any rate, DT Swiss makes a 12mm x 135mm Freeride hub, you can probably use that for a 14mm drop-out without the need to use adaptors.
https://www.dtswiss.com/Products/Comp...-freeride.aspx
.
At any rate, DT Swiss makes a 12mm x 135mm Freeride hub, you can probably use that for a 14mm drop-out without the need to use adaptors.
https://www.dtswiss.com/Products/Comp...-freeride.aspx
.
#4
Te mortuo heres tibi sim?
Join Date: Aug 2004
Location: East coast
Posts: 3,486
Bikes: hardtail, squishy, fixed roadie, fixed crosser
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
what frame? that's a very weird axle size. there have been a few frame makers in the past who used proprietary sizes - a frame purchase usually came with the hub that was specific to the frame.
you sure it isn't a 12mm axle? or, there are some frames floating around with 15mm rear axles as well.
thankfully, things are getting a bit more "standardized" now.
you sure it isn't a 12mm axle? or, there are some frames floating around with 15mm rear axles as well.
thankfully, things are getting a bit more "standardized" now.
#5
Junior Member
Thread Starter
Join Date: Jul 2009
Location: SLC
Posts: 7
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
it very well may be a 15mm axle but the guy i bought it from at go ride told me it was a 14 so.. and its an Ellsworth Dare frame
#7
Senior Member
Join Date: Feb 2009
Location: Austin, TX
Posts: 208
Bikes: Giant XTC Team Custom XC bike, Nashbar tourer custom commuter
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
15mm is the standard for beefed up axles, so that's probably it. You probably don't need a caliper to get close enough, just measure the axle/hub hardware/dropouts and see if they're a bit larger than 14mm.