Another dull question about installing my Flight Deck
#1
1/2 man,1/2 bear,1/2 pig
Thread Starter
Join Date: May 2004
Location: .
Posts: 1,122
Bikes: .
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Another dull question about installing my Flight Deck
OK, this is frustrating -- went to the shop today and swapped out the mounting kit for the correct 9-speed mounting kit for my 9-spd Ultegra. The buttons now match up properly. However, when the head unit (display) is mounted, it keeps flickering. I tried removing the L side and R side buttons individually and 1 at a time, and no change whether they are installed or not. It's when the head unit is snapped onto the bracket that I get the flickering. The buttons don't work when they are installed.
I set the bike no. to #2 and set it up properly first. This is my 10-spd head unit, and the shop says there is no other HU....that it should work with the 9-spd mounting kit. (of course, i am well aware about de-programming the 10th cog to make it a 9-spd display).
any solutions to this erratic behavior?
I set the bike no. to #2 and set it up properly first. This is my 10-spd head unit, and the shop says there is no other HU....that it should work with the 9-spd mounting kit. (of course, i am well aware about de-programming the 10th cog to make it a 9-spd display).
any solutions to this erratic behavior?
__________________
...
...
#2
It's ALL base...
Join Date: Aug 2006
Location: Los Angeles
Posts: 6,716
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Perhaps the head unit is making intermittent contact with the base?
Try cleaning all the contacts by rubbing with with a rubber eraser and checking that the pointy parts on the head unit are making solid contact with the contacts on the base unit.
I would think if you only get this problem when the head unit is mounted on the bracket, there's a problem with either the bracket (maybe its wiring?) or the interface (contact between the two).
Maybe you got a faulty mounting kit...
Try cleaning all the contacts by rubbing with with a rubber eraser and checking that the pointy parts on the head unit are making solid contact with the contacts on the base unit.
I would think if you only get this problem when the head unit is mounted on the bracket, there's a problem with either the bracket (maybe its wiring?) or the interface (contact between the two).
Maybe you got a faulty mounting kit...
#3
Senior Member
Join Date: May 2005
Location: SFBay
Posts: 2,334
Bikes: n, I would like n+1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 127 Post(s)
Likes: 0
Liked 133 Times
in
108 Posts
there are little stickers that fit under the contacts in the hoods to keep them pressed togeather. If you read the direction manual you'll see a picture of what they look like.