Torque spec on Quarq Riken cranks(SRAM)
#1
Powered by Borscht
Thread Starter
Join Date: Jul 2005
Location: SoCal
Posts: 8,342
Bikes: Russian Vodka
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Torque spec on Quarq Riken cranks(SRAM)
The 8mm inner torque spec on the crank says 425 in-lb and the 10mm says 120 in-lb.
I dont have a 10mm, but I do have an 8mm. Seriously 425 in-lb is A LOT.
My torque wrench only goes up to like 250 in-lb...
Thoughts?
I dont have a 10mm, but I do have an 8mm. Seriously 425 in-lb is A LOT.
My torque wrench only goes up to like 250 in-lb...
Thoughts?
#2
Member
Join Date: Oct 2009
Location: Nor Cal
Posts: 825
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Liked 0 Times
in
0 Posts
I torqued mine to 35 ft-lb (420 in-lb). I went a little under that at first and had some lateral play, so I loosened it back up (not with the torque wrench) and re-did it. No more play.
That's about the same torque as other SRAM cranks.
Bob
That's about the same torque as other SRAM cranks.
Bob