Advertise on Bikeforums.net



Search:

Type: Posts; User: Werkin; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.91 seconds.

  1. An FYI on most off-the-shelf sizing. Fork...

    An FYI on most off-the-shelf sizing. Fork size/spec remains the same for a manufacturer's model range, so viewing the HA in isolation, slacken the HA by 1 degree or greater increases trail...
  2. I looked at the specs on the Trek Crockett in...

    I looked at the specs on the Trek Crockett in size 50, generous F/C guess is only about 58.5cm. Wheelbase 100.1cm - chainstay length 42.5cm = 57.6cm, add ~7mm for BB drop of 7cm for virtual...
  3. An off-the-shelf frame with long F/C in size 50...

    An off-the-shelf frame with long F/C in size 50 is out of the ordinary.

    More information about the test bike please; BB drop, crank arm length, head tube angle, fork axle to crown, and fork rake?...
  4. Replies
    5
    Views
    317

    Home (http://www.youngwheels.com/) Granbury

    Home Granbury
  5. Replies
    10
    Views
    700

    Not Stupid

    It's a very good idea on many levels. To achieve the most performance potential using a high volume/low pressure tire, mount them on appropriate width rims. Think 29mm or greater inner width. ...
  6. Thread: Rotor Question

    by Werkin
    Replies
    6
    Views
    418

    I suggest direct from TRP if you haven't tried...

    I suggest direct from TRP if you haven't tried that option.

    There are better rotors available than those from TRP, and better PM/IS adaptors also (at least adaptors that will accommodate a wider...
  7. Thread: Hybrid to cx?

    by Werkin
    Replies
    16
    Views
    1,418

    I'm aware you have your mind set on drop bars,...

    I'm aware you have your mind set on drop bars, but since you invited an alternative. An entry level suspension fork with drop bars on top is a poor combination. I suggest a wider flat bar,...
  8. Replies
    9
    Views
    1,094

    Hetre 42mm nominal (47-48mm mounted), Pari-Moto...

    Hetre 42mm nominal (47-48mm mounted), Pari-Moto 38mm nominal (43mm mounted)
    33 R, 30 F
    Orange Seal
    Single rider only, 213 - 217 bike & rider.
  9. Replies
    9
    Views
    1,094

    I have wide hookless carbon rims...

    I have wide hookless carbon rims, and run supple high volume/low pressure road tires with and without tubes. The tires are designed for tubes and hooked rims, yet they seal securely when installed...
  10. In my application there were a few minor...

    In my application there were a few minor tradeoffs. Occasionally, there is a little chain to sprocket noise when shifting, and the range for appropriate cable tension became very narrow. The good...
  11. I'll add a non-campy data point, Praxis Works...

    I'll add a non-campy data point, Praxis Works cyclocross chain rings, SRAM 10 speed Rival crank/spider, Shimano FD-CX70 10 speed, Shimano CN-9000 11 speed chain, SRAM 1091 10 speed cassette and XX...
  12. Thread: SRAM goes 1x

    by Werkin
    Replies
    20
    Views
    1,217

    I like it. Right, I've done it, reduces...

    I like it.


    Right, I've done it, reduces chain drop here too.



    I'm using both clutch and non clutch MTB RDs with SRAM Force 10 speed shifters.
  13. Replies
    16
    Views
    407

    Another compatibility confirmation here for 10...

    Another compatibility confirmation here for 10 speed MTB RDs. I've used the X9 Type II, and currently use the XX rear derailleurs with Force 10 speed shifters. FYI, the Type II medium cage has 35T...
  14. Replies
    27
    Views
    859

    http://www.voler.com/browse/product/li/1110554 ...

    http://www.voler.com/browse/product/li/1110554 Search for a web coupon.
  15. Replies
    345
    Views
    41,549

    Make sure the lock-out screw can be screwed down,...

    Make sure the lock-out screw can be screwed down, pad gap can not self-adjust if the piston cylinder can not refill. This top-off procedure is helpful: https://www.youtube.com/watch?v=S0i4aQ8S34w
  16. Replies
    49
    Views
    2,174

    Here you go -...

    Here you go - http://www.voler.com/browse/product/li/1110554
    Before balking at the price, search for a coupon code. These are outstanding bib shorts.
  17. Replies
    345
    Views
    41,549

    FYI, there have been a few changes since the...

    FYI, there have been a few changes since the early version of the Hy/Rd caliper. For 2014 a set-screw has been added to the plunger rod to discourage user manipulation, reservoir volume has...
  18. Replies
    31
    Views
    2,685

    More mechanical advantage than traditional side...

    More mechanical advantage than traditional side pull/dual pivot calipers.

    https://lh6.googleusercontent.com/-3fLaVDZRNc4/UfT2qnHzstI/AAAAAAAAA0I/vzqVDW1ZO-I/s400/P1020362.JPG


    I don't have an...
  19. Replies
    31
    Views
    2,685

    Modulation is user control up to and including...

    Modulation is user control up to and including the threshold of lock-up. Power in my description can be defined as low lever effort required for rapid slowing. A stick in the spokes can lock a...
  20. Replies
    31
    Views
    2,685

    SwissStop BXP (blue) pads will improve both power...

    SwissStop BXP (blue) pads will improve both power and modulation with any rim brake on aluminum rims.

    Shimano 6800 and 9000 series brake calipers are not like traditional dual pivot center mount...
  21. Replies
    345
    Views
    41,549

    The original pad adjustment screw was also a 3mm...

    The original pad adjustment screw was also a 3mm hex, it was located within the center of the outboard arm's torx fastener.
  22. Replies
    7
    Views
    432

    Terry (RT Wheelcraft) built a set of wheels for...

    Terry (RT Wheelcraft) built a set of wheels for me; great workmanship and attention to details.
  23. Replies
    345
    Views
    41,549

    I contacted TRP in the U.S. with a few questions...

    I contacted TRP in the U.S. with a few questions including how the Stop Sell notice effects consumers. They have not formulated a plan at this point. The person I spoke with shared some of their...
  24. Replies
    2
    Views
    307

    The top can mount a 180mm rotor in the front, or...

    The top can mount a 180mm rotor in the front, or 160mm in the rear. The bottom bracket can mount a 160mm up front or 140mm in the rear. A 200mm up front takes a 40mm IS bracket, a 203mm up front...
  25. Replies
    345
    Views
    41,549

    My guess, the rest of the world lists the day...

    My guess, the rest of the world lists the day followed by the month, and that's why the date appears retro at first glance on the German notice.
Results 1 to 25 of 497
Page 1 of 20 1 2 3 4