gradient feature stopped working-Edge 500
#1
Full Member
Thread Starter
Join Date: Jan 2013
Location: Hogansville GA
Posts: 311
Bikes: Too damn many to list, seriously.
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 96 Post(s)
Likes: 0
Liked 26 Times
in
14 Posts
gradient feature stopped working-Edge 500
I was riding today and looked down to check the grade on a hill I was climbing and it was on 0% on an obvious 4% or so grade. The grade feature didn't work for the remainder of the ride, yet it recorded the total ascent. I know the grade was working early during the ride, because I checked it on another hill. Any ideas? I have always updated the unit each time it says an update is available.
#2
Zoom zoom zoom zoom bonk
Join Date: Sep 2006
Location: New Zealand
Posts: 4,624
Bikes: Giant Defy, Trek 1.7c, BMC GF02, Fuji Tahoe, Scott Sub 35, Kona Rove, Trek Verve+2
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 551 Post(s)
Liked 722 Times
in
366 Posts
Might be a bit of water in it messing with the sensor, happens to mine now and then.
#3
Senior Member
Join Date: May 2008
Location: Zang's Spur, CO
Posts: 9,082
Mentioned: 11 Post(s)
Tagged: 0 Thread(s)
Quoted: 3374 Post(s)
Liked 5,508 Times
in
2,853 Posts
My 705 does that on rare occasions.
AFAIK, only a powercycle will make the display return.
AFAIK, only a powercycle will make the display return.
#4
Full Member
Thread Starter
Join Date: Jan 2013
Location: Hogansville GA
Posts: 311
Bikes: Too damn many to list, seriously.
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 96 Post(s)
Likes: 0
Liked 26 Times
in
14 Posts
Apparently it was just a fluke thing. because it has worked every time since.