Installing an 11-32 cassette
04-10-06, 05:04 PM
#1
Senior Member
Thread Starter
Installing an 11-32 cassette
I am planning on installing an 11-32 9 spd cassette on a ultegra freehub (circa 2002). I saw some stuff on Sheldon Brown site about having to place a spacer behind the cassestte. Have any of you done used this type of set-up, and what was your experience?
thanks
thanks
04-10-06, 05:28 PM
#2
Its only pain
Join Date: Oct 2004
Location: Hammond, WI
Posts: 930
Bikes: '18 Salsa Marrakesh, '14 Salsa Colossal, '89 GT Timberline
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 54 Post(s)
Likes: 0
Liked 4 Times
in
4 Posts
If the hub is 9 speed the 11-32 will fit. You'll need a mountain bike rear derailleur to have it work properly, though.
04-10-06, 11:55 PM
#3
WATERFORD22
Join Date: Oct 2005
Location: Seattle
Posts: 509
Bikes: Bilenky, Co-Motion, 1969 Paramount, Waterford Adventure Cycle, Waterford rs 22, 1980 Davidson etc.
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I am running this same set up 36 hole Ultegra hubs spaced for 135 - 11-32 cassette running with a XT rear and a Ultrgra triple front - no problem works fine
