Polar CS200CAD
#1
phipsy
Thread Starter
Join Date: Apr 2008
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Polar CS200CAD
Hi All,
I have recently purchase a POLAR CS200 CAD bike computer, have setup most of the settings which was fairly straight forward, but I am still unsure how to change the KM to MPH, very frustrating after looking through the manual and online for help. I have read that you can change the setting on the Polar Uplink toll but didn't have much luck with it.
Any help or guidance will be much appreciated.
Cheers.
Phipsy.
I have recently purchase a POLAR CS200 CAD bike computer, have setup most of the settings which was fairly straight forward, but I am still unsure how to change the KM to MPH, very frustrating after looking through the manual and online for help. I have read that you can change the setting on the Polar Uplink toll but didn't have much luck with it.
Any help or guidance will be much appreciated.
Cheers.
Phipsy.
#2
Newbie
Join Date: Apr 2008
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
phipsy
cycle through the pages to settings and press start
cycle through to general and press start
cycle through to units and change from kg/cm to lb/ft and press ok
this should change your km's to mph
cycle through the pages to settings and press start
cycle through to general and press start
cycle through to units and change from kg/cm to lb/ft and press ok
this should change your km's to mph