Campy BB Bearing Retainer?
#1
Senior Member
Thread Starter
Join Date: Feb 2008
Location: Carson Valley Nevada
Posts: 226
Bikes: Cervelo Serotta Santa Cruz
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Campy BB Bearing Retainer?
This thing.
I can understand the purpose of this clip while installing the crank but what purpose does it serve after installation? Is it necesary.
I can understand the purpose of this clip while installing the crank but what purpose does it serve after installation? Is it necesary.
#2
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
Is this the bearing retainer from an UltraTorque bb?
#3
Senior Member
Join Date: Sep 2006
Location: Waterford,WI
Posts: 281
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Looks like the clip from the Ultratorque BB. Yes it is necessary, it keeps the bearings in place. Without it, the bearings and shaft will be able to move side to side.
#4
Senior Member
Thread Starter
Join Date: Feb 2008
Location: Carson Valley Nevada
Posts: 226
Bikes: Cervelo Serotta Santa Cruz
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Yes, it is on my Record 10 speed Ultra torque BB
I had taken it all apart to see if the BB was part of a creak (it wasn't) and fiorgot to put it back on. I can't detect any side to side movement in bearings or shaft without it but I'll snap it back in. Certainly won't slow me down.
Thanks
I had taken it all apart to see if the BB was part of a creak (it wasn't) and fiorgot to put it back on. I can't detect any side to side movement in bearings or shaft without it but I'll snap it back in. Certainly won't slow me down.
Thanks