Finally got out on my new Brooks saddle
08-08-11, 05:17 PM
#1
Senior Member
Thread Starter
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 29,545
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Mentioned: 112 Post(s)
Tagged: 0 Thread(s)
Quoted: 5222 Post(s)
Liked 3,576 Times
in
2,340 Posts
Finally got out on my new Brooks saddle
embarrassed to say I don't remember the last bike ride but today I finally installed my new Brooks saddle and gave it a 10 mile test ride. initially I found it very slippery which is kinda cool for a saddle. after a while I realized it was pretty comfortable without the usual sit-bone discomfort. when installing it I was displeased with the rails' shape because I was unable to match my usual 19.5 inches from bar to saddle nose. I wanted to slide the saddle further back but could not due to the shape of the rails. I think it will be OK, the ride seemed comfortable enough with the saddle where it is. I guess it's been so hot, maybe I'll ride more this fall.
Last edited by rumrunn6; 08-08-11 at 08:10 PM.
08-09-11, 07:14 AM
#5
Senior Member
Thread Starter
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 29,545
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Mentioned: 112 Post(s)
Tagged: 0 Thread(s)
Quoted: 5222 Post(s)
Liked 3,576 Times
in
2,340 Posts
oh, tan bar tape. that's a good idea. any suggestions? I'm used to stretchy cork tape. not sure "leather" tape is the way to go.
