Since you are soon to restock your Dolan supply, will you have any track champions in stock or do you mostly just carry pre-cursas and order out the more specialty ones?
@Scrodzilla, I did. Sorry, man. I haven't gotten a chance to check my email for a while. Been a busy week!
I'm just deciding on when I should buy them, there's a couple other things I want ATM.
If you're in or anywhere near San Diego on Saturday Feb 1st, there's no good reason not to show up for this.
We will have a keg, pizza from Luigi's and tons of great stuff to give away among other things (but we will not have a stupid DJ).
shiiitt im so jelly, i wanna play bikes
ride bikes, eat food. the circle of life.
I'll be in town at the end of February, just found out today!
God damn I wish I could go to that.
Originally Posted by johnnytheboy
nice im in.
how many people are you guys expecting? just curious.
"Your beauty is an aeroplane;
so high, my heart cannot bear the strain." -A.C. Jobim, Triste
I'll do it for the free beer.
I will be stopping in for sure, I need to pick up some things!
I'm hoping I can meet up with a few of you guys for some beers and bike talk while I'm in town too.
I couldn't find the ask scrod thread so forgive me if this isn't the place, but I'm sure you get this question a lot
thinking of doing sapim spokes on this next wheelbuild. any idea what the length required on a 3x pattern would be for dura ace 7600 28h to h+son archetype? the calculator on prowheelbuilder shows 293 but I think that may be for low flange
The specs for 7600 hubs is listed on our site.
According to my calculations using this, I'm getting 292.4 front/292.0 rear. Personally, I would use 291mm for both wheels.
you rock, thanks