Removing Braze-ons...
#1
Senior Member
Thread Starter
Removing Braze-ons...
I just procured a classic Nishiki International frame, in my size, with which I am going to replace my current, wee bit undersized frame. I purchased this frame specifically to be used as a fixie, so I'd like to remove the braze-on cable ends and whatnot. What's the best way to do so? Will a Dremel handle it? Or should I try and wrap the frame around a wheel grinder? Maybe a chisel to the brazing?
Thanks!
Thanks!
__________________
https://www.pedalroom.com/members/iamtim
https://www.pedalroom.com/members/iamtim
#3
crotchety young dude
Join Date: Jan 2005
Location: SF, CA
Posts: 4,818
Bikes: IRO Angus; Casati Gold Line; Redline 925; '72 Schwinn Olympic Paramount
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Dremel. Although I simply pounded them off with a screwdriver chisel.
#4
Team Beer
Join Date: Apr 2004
Location: Sacramento CA
Posts: 6,339
Bikes: Too Many
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Quoted: 114 Post(s)
Liked 159 Times
in
104 Posts
Get a propane torch and heat them up. It's way cleaner than a dremel of a grinder plus you won't worry about grinding thru the tube. A torch is how they got there and a torch is the best way to get them off.
__________________
I'm not one for fawning over bicycles, but I do believe that our bikes communicate with us, and what this bike is saying is, "You're an idiot." BikeSnobNYC
I'm not one for fawning over bicycles, but I do believe that our bikes communicate with us, and what this bike is saying is, "You're an idiot." BikeSnobNYC
#5
WTF?
Join Date: Apr 2005
Location: livin' the dream
Posts: 462
Bikes: trek cross, gt mtb, khs track
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
if you actually want the entire braze-on off, and have a propane torch, go with a torch.
if you have very steady hands and are patient you could probably do it with a dremel.
if it were me, i'd probably use the dremel and take off most of the braze on and just leave the base so i don't risk cutting into the tube. or you could use a dremel for most of it and take the base off with a file. you'd be surprised how well a properly used file works. just take your time and check the progress after every stroke or two.
now that i think about it, the dremel/file solution would probably do the least damage to the paint. so i'd do that.
if you have very steady hands and are patient you could probably do it with a dremel.
if it were me, i'd probably use the dremel and take off most of the braze on and just leave the base so i don't risk cutting into the tube. or you could use a dremel for most of it and take the base off with a file. you'd be surprised how well a properly used file works. just take your time and check the progress after every stroke or two.
now that i think about it, the dremel/file solution would probably do the least damage to the paint. so i'd do that.