Sugino Messenger Bottom Bracket
almost done with the build of my second bike and i wanted to get some feedback on a BB ot run on my pake (68 mm BB shell). i just got messenger cranks 165mm 46t and 1/8 with 17t cog on the rear. ive been looking at the Sugino Bottom Bracket and IRD QB-75 JIS Square Taper both 68x103 . Any feedback on either of these or any other recommendations that are not to ridiculously expensive would greatly be obliged. thanks
|
Got the same thing going, Pake 53cm w/ Sugino RD's. The thing with the them is that they're gonna give you a 45mm chainline with the BB recommended. You might have to put the chainring on the inside of the spider. I've got mine on the outside, with an EAI cog in the back since they supposedly sit out a little further from the hub (it looks wider against a Soma cog). Do a search on this topic, it's been covered a lot.
|
Originally Posted by cJajce
(Post 7384385)
almost done with the build of my second bike and i wanted to get some feedback on a BB ot run on my pake (68 mm BB shell). i just got messenger cranks 165mm 46t and 1/8 with 17t cog on the rear. ive been looking at the Sugino Bottom Bracket and IRD QB-75 JIS Square Taper both 68x103 . Any feedback on either of these or any other recommendations that are not to ridiculously expensive would greatly be obliged. thanks
|
All times are GMT -6. The time now is 07:41 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.