Sugino Messenger Bottom Bracket
#1
Member
Thread Starter
Join Date: Jun 2008
Posts: 38
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Sugino Messenger Bottom Bracket
almost done with the build of my second bike and i wanted to get some feedback on a BB ot run on my pake (68 mm BB shell). i just got messenger cranks 165mm 46t and 1/8 with 17t cog on the rear. ive been looking at the Sugino Bottom Bracket and IRD QB-75 JIS Square Taper both 68x103 . Any feedback on either of these or any other recommendations that are not to ridiculously expensive would greatly be obliged. thanks
#2
thread derailleur
Join Date: May 2008
Location: beyond Thunderdome
Posts: 1,095
Bikes: 82 Bianchi ECO Pista, Pake, Kilo TT, some *** bmx i found underneath an old house
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Got the same thing going, Pake 53cm w/ Sugino RD's. The thing with the them is that they're gonna give you a 45mm chainline with the BB recommended. You might have to put the chainring on the inside of the spider. I've got mine on the outside, with an EAI cog in the back since they supposedly sit out a little further from the hub (it looks wider against a Soma cog). Do a search on this topic, it's been covered a lot.
#3
cab horn
Join Date: Jun 2004
Location: Toronto
Posts: 28,353
Bikes: 1987 Bianchi Campione
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 42 Post(s)
Likes: 0
Liked 26 Times
in
19 Posts
almost done with the build of my second bike and i wanted to get some feedback on a BB ot run on my pake (68 mm BB shell). i just got messenger cranks 165mm 46t and 1/8 with 17t cog on the rear. ive been looking at the Sugino Bottom Bracket and IRD QB-75 JIS Square Taper both 68x103 . Any feedback on either of these or any other recommendations that are not to ridiculously expensive would greatly be obliged. thanks