You run the cable thru the barrel adjuster on top and stop the housing there. Loosen the bolt on the bottom arm and pass the cable between the square nut and quick release inside the bolt. After adjustment you tighten the bolt to secure the cable.
the cable goes through that knurled receiver at the top, then gets clamped right below it via allen bolt and a plate that holds it down. you feed the cable through the hole, then clamp it when you have the desired brake pad play
he starts with derailleurs and what not, but it's the same concept
Unscrew the screw that is circled, and then where the smaller circle is, there should be a groove or a knurled-like surface on that little square piece you have that goes against the cable. Put the cable between that piece and the brake, then tighten the screw down, clamping the cable between the two.
awesome! thank you so much, that helped a lot haha
Make sure you get some cable housing if you don't have some already.
Last edited by PeDDeR27; 05-28-11 at 01:44 AM.