Road bike with 32 spoke wheels.. feasible?
#1
Senior Member
Thread Starter
Join Date: Jul 2008
Location: Vancouver, BC
Posts: 221
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Road bike with 32 spoke wheels.. feasible?
A friend an I are doing a West Coast tour this summer. Eugene to SF. While I have a genuine touring bike, my touring partner opted to purchase a road bike for the job. It's a Sora-equipped Trek 1200 from the late 90s, early 2000s. It has eyelets for racks and all that. My bigger concern are the wheels. 32 spoked no-namers.
Here's the dilemma. He's coming to the end of his gear budget, so we're trying to figure out what's necessary. He's a fairly light guy at 5'9, 150-160lbs. His gear, while not ultra-lightweight, is still on the light side of things. (hammocks, small sleeping bag, etc.)
Do you think he can forgo new 36-spoke wheels and get away with the existing 32? Or is that a really bad idea? I was thinking that he can probably get away with just a rear 36-spoke wheel, as most of the weight is on the back. But, if we can go with the 32s, life would be a lot easier.
At this point, a BOB trailer isn't an option.
What say you bikeforums/touring?
Here's the dilemma. He's coming to the end of his gear budget, so we're trying to figure out what's necessary. He's a fairly light guy at 5'9, 150-160lbs. His gear, while not ultra-lightweight, is still on the light side of things. (hammocks, small sleeping bag, etc.)
Do you think he can forgo new 36-spoke wheels and get away with the existing 32? Or is that a really bad idea? I was thinking that he can probably get away with just a rear 36-spoke wheel, as most of the weight is on the back. But, if we can go with the 32s, life would be a lot easier.
At this point, a BOB trailer isn't an option.
What say you bikeforums/touring?
#3
Senior Member
Join Date: Aug 2005
Posts: 3,871
Mentioned: 14 Post(s)
Tagged: 0 Thread(s)
Quoted: 598 Post(s)
Liked 283 Times
in
194 Posts
If he weighs in at 155 lbs and you keep rear weight to 25 lbs, I would think 180 lbs should be a piece of cake, assuming as 10 Wheels said, that the wheel has been gone over and in good shape. And yea, a rear wheel alone with 36 spokes is often sufficient.
#4
Senior Member
Join Date: May 2011
Location: the LOU, Mo
Posts: 584
Bikes: Bianchi Nuevo Alloro, Cannondale ST400, Fuji Palisade, GT Timberline FS, Raleigh Technium 420, Schwinn Moab, Schwinn Passage, Schwinn Tempo, Specialized Sirrus Elite (aluminum), Specialized Sirrus Triple (steel), Trek 7.6, Viner Road Record
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 15 Post(s)
Liked 65 Times
in
19 Posts
My 80's Schwinn Passage was equipped with a 36f/40r set when I got her. That set was overkill for LIGHT touring. I have a second set of 32's that I ran most of the time. ( My weight back then was 165,i'm @ 200 now... ) I run those 32's unloaded all the time now.
#5
Senior Member
There's nothing magical about the number 36. A poorly built 36 spoke wheel can be weak, and a good 32 spoke wheel can be strong. I see heavy guys riding 20f/24r spoked wheels and their rider+bike weight far exceeds your friend's body+bike+gear weight, and that's for 24 spokes. A properly tuned 32 should be just fine.
#6
nashcommguy
Join Date: Feb 2006
Location: nashville, tn
Posts: 2,499
Bikes: Commuters: Fuji Delray road, Fuji Discovery mtb...Touring: Softride Traveler...Road: C-dale SR300
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
#7
Senior Member
Join Date: Sep 2008
Posts: 5,200
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 137 Post(s)
Likes: 0
Liked 81 Times
in
64 Posts
number of spokes really doesn't tell enough about the condition of THAT particular set of wheels. 32 spokes on 10yr old wheels could be fine, 36spokes on ten year old wheels could be iffy. Have someone check the wheel. If in doubt move weight forward.
#8
Senior Member
Join Date: Mar 2009
Location: Oregon
Posts: 6,489
Mentioned: 31 Post(s)
Tagged: 0 Thread(s)
Quoted: 1182 Post(s)
Liked 833 Times
in
435 Posts
As almost everyone else has said, 32s are fine. I'm about the same weight, carry about 40 lbs, and used 32spoke wheels on my cross bike for some pretty serious tours. They did fine untill I rode off a high curb fully loaded, and my front wheel started popping spokes--not the wheels fault. It might be good to use 25mm or 28s tires if his bike has the clearance. Another good investment for the TREK is a 11-34 rear cassette with a long cage Mtn rear derailleur (Shimano Deore); especially for that hill south of Elk, CA. IMO, I'd opt for lower gearing and go with the existing wheels. It is a lot cheaper (about $60-$75) and will be appreciated on the hills.
Bianchi Volpe set up for touring with 32 spoke wheels.
This is a TREK 1000 with stock 32 spoke wheels and 25mm tires that I have used for light touring. It would handle anything on the coast route.
Bianchi Volpe set up for touring with 32 spoke wheels.
This is a TREK 1000 with stock 32 spoke wheels and 25mm tires that I have used for light touring. It would handle anything on the coast route.
Last edited by Doug64; 06-04-11 at 11:46 PM.
#9
Senior Member
Join Date: Aug 2006
Location: Central Coast, CA
Posts: 3,392
Bikes: Surly LHT, Specialized Rockhopper, Nashbar Touring (old), Specialized Stumpjumper (older), Nishiki Tourer (model unknown)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
A good 32-spoke wheel should be fine, especially at his weight. Get it evaluated by a competent pro. It should probably be trued and tensioned.
If he's worried, it might be worth it to have a new, 36-spoke wheel built by someone good.
Is he going to be using a front rack? You can take a lot of weight off the back by putting it in front. Maybe that would be the best use of his funds?
He's got some options, and I think all of them are very do-able.
Have a great trip! That is one of my favorite routes! You'll meet lots of other tourers.
If he's worried, it might be worth it to have a new, 36-spoke wheel built by someone good.
Is he going to be using a front rack? You can take a lot of weight off the back by putting it in front. Maybe that would be the best use of his funds?
He's got some options, and I think all of them are very do-able.
Have a great trip! That is one of my favorite routes! You'll meet lots of other tourers.
#10
totally louche
Join Date: Oct 2004
Location: A land that time forgot
Posts: 18,023
Bikes: the ever shifting stable loaded with comfortable road bikes and city and winter bikes
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 10 Times
in
9 Posts
Question is, how old is the current wheel and how road worn?
As to hand built, ready made touring wheels for road spaced bikes, a Tiagra road hub laced to a Mavic A319 rear wheel sets a person back 109 USD at Gregg's Greenlake Cycle in Seattle last time I was in there and they usually keep them in stock.A wheelset was like 200 bucks american.
if your friend can limp along as far as Seattle, go by and pick up a new rear wheel, stout as they come, for a little over a hundred bucks USD. I'd call a day or two ahead to secure one for you, as they are pretty busy shop.
As to hand built, ready made touring wheels for road spaced bikes, a Tiagra road hub laced to a Mavic A319 rear wheel sets a person back 109 USD at Gregg's Greenlake Cycle in Seattle last time I was in there and they usually keep them in stock.A wheelset was like 200 bucks american.
if your friend can limp along as far as Seattle, go by and pick up a new rear wheel, stout as they come, for a little over a hundred bucks USD. I'd call a day or two ahead to secure one for you, as they are pretty busy shop.
#12
Banned
Bring spare spokes , yes, + Bring enough money (credit/debit card)
to replace the wheel in the middle of the trip, if there are unforeseen problems.
to replace the wheel in the middle of the trip, if there are unforeseen problems.
Last edited by fietsbob; 06-05-11 at 11:29 AM.