Lube for winter
#1
Senior Member
Thread Starter
Join Date: Jul 2002
Location: Biddeford, Maine, USA
Posts: 424
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Lube for winter
Hi; I have used Bar and Chain oil on my chain for the past two winters. My local bike shop had a trainee clean my drivetrain during my last tuneup. He was quite disgusted with how long it took him to clean all the crude out of the chain and the springs.
Bar and Chain oil works great, but I wonder if there is something as effective, which would work as well if not better.
So, what are other people using?
Bar and Chain oil works great, but I wonder if there is something as effective, which would work as well if not better.
So, what are other people using?
#2
Year-round cyclist
Join Date: Apr 2002
Location: Montréal (Québec)
Posts: 3,023
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
What do I use?
Bearing grease.
I apply it on the chain and wipe it with a paper towel. I also put lots of grease on top of the bearing (to seal them off, sort of), and a thin coat on the bottom bracket and other vulnerable parts.
Regards,
Bearing grease.
I apply it on the chain and wipe it with a paper towel. I also put lots of grease on top of the bearing (to seal them off, sort of), and a thin coat on the bottom bracket and other vulnerable parts.
Regards,
#3
Senior Member
Join Date: Sep 2002
Location: Rochester, Minnesota
Posts: 136
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I have heard from an experienced winter rider that icewax chain lube works exceptionally well, especially if applied several times to build up a thicker coating.
#4
RAGBRAI. Need I say more?
Join Date: Apr 2001
Location: West Branch, Iowa USA
Posts: 868
Bikes: 1998 Mongoose NX7.1, 2008 Kona Jake, GT singlespeed (year unknown).
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I use Finish Line Cross Country in the winter. Sludge will build up in the cogs and rear deraileur area, but with frequent chain cleanings and an occasional cog scrub, this will not be a problem.
#5
Senior Member
Thread Starter
Join Date: Jul 2002
Location: Biddeford, Maine, USA
Posts: 424
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
That raises another question. What method of chain cleaning do you all use? Sheldon Brown says on bike is not all that bad. Does anyone use such a device? If so, what make/model? Thanks.
#6
Senior Member
Join Date: Jul 2000
Location: Snowy midwest
Posts: 5,391
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Winter riding is different from fair weather riding. You have to use chain lube that will stay on an take the abuse of road salt, slush, and REAL grime.
The new wrench weenie who thought your chain was icky needs to go back to work at McDonalds. Leave bike work up to guys who's fingers are always blacker than their own "O-ring".
In Montreal, where you are, a lot of guys use heavy weight motor oil on their chains.
The new wrench weenie who thought your chain was icky needs to go back to work at McDonalds. Leave bike work up to guys who's fingers are always blacker than their own "O-ring".
In Montreal, where you are, a lot of guys use heavy weight motor oil on their chains.
#7
Senior Member
Join Date: Feb 2001
Location: England
Posts: 12,948
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 19 Post(s)
Likes: 0
Liked 7 Times
in
7 Posts
I have problems applying some of those wax-in-solvent lubes at low temp. White Lightening is supposed to be applied down to 10C, but it seems to solidify on contact below about 12C.
A hot wax chain dip is used by some people. This will protect the chain from rust. If the wax has some slippery addatives (teflon, Moly Disulphide) it will lube OK. Ive seen commercial motorbike hot wax dip, but for bikes it is a DIY operation.
I use a layer of wax on any exposed metal, and wax the painted frame to shed winter road muck. Car wax works fine for this.
A hot wax chain dip is used by some people. This will protect the chain from rust. If the wax has some slippery addatives (teflon, Moly Disulphide) it will lube OK. Ive seen commercial motorbike hot wax dip, but for bikes it is a DIY operation.
I use a layer of wax on any exposed metal, and wax the painted frame to shed winter road muck. Car wax works fine for this.
Last edited by MichaelW; 10-03-02 at 06:49 AM.
#8
Year-round cyclist
Join Date: Apr 2002
Location: Montréal (Québec)
Posts: 3,023
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
I'm aware some people use [heavy] motor oil as lubricant.
However, there is a major problem with it: it's messy -- a problem as I commute in street clothes.
Regards,
However, there is a major problem with it: it's messy -- a problem as I commute in street clothes.
Regards,
#9
Senior Member
Join Date: Jul 2000
Location: Snowy midwest
Posts: 5,391
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
Originally posted by mgagnonlv
I'm aware some people use [heavy] motor oil as lubricant.
However, there is a major problem with it: it's messy -- a problem as I commute in street clothes.
Regards,
I'm aware some people use [heavy] motor oil as lubricant.
However, there is a major problem with it: it's messy -- a problem as I commute in street clothes.
Regards,
If you typically wear your work clothes while you commute, consider wearing knee-high gators. They will keep your pants clean and add some warmth.
#10
Member
Join Date: Jul 2002
Location: Verona, WI
Posts: 31
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I have heard form some local riders that are experienced whit winter riding and that I have talked to recently say that heavy weight motor oil works well around these parts. And wax the bike with car wax.....keep the road crude off as much as possible. We'll see how it works..........