View Single Post
Old 04-02-05, 05:54 PM
The Red Lantern
Rev.Chuck's Avatar
Join Date: Apr 2003
Location: Raleigh NC
Posts: 5,965
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
That is what it is for. Once you get the axle out you should be able to pop the seals out with a screwdriver. There is a tool that is length of rod with the end ground rounded and then bent back into a tight J shape. You could make one of these for popping out seals. It is easier on them a screwdriver as, if you make it right, it levers against the interior of the hub rather than the edge of the seal. Sometimes a wide blade screwdriver will catch the lip of the race and you can twist the seals out that way as well.
Are you a registered member? Why not? click here to register. Its free, and only takes 27 seconds!
Help out the forums, abide by our community guidelines.

I am in the woods and I have gone crazy.
Rev.Chuck is offline