View Single Post
Old 10-08-02, 06:16 PM
  #2  
Flatland Freak
I HAVE A BIG
 
Flatland Freak's Avatar
 
Join Date: Feb 2002
Location: Skowhegan,Maine
Posts: 167
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
If you dont have the right tools there are always ways to get around it. Just use a hammer to pound out the spindle..if you have to hit it hard put a piece of wood on it before you hit it. To get the bearings out just take a small socket and a long socket wrench extention (or anything else that has a big blunt surface that wont hurt the bearing that fits in the hole) ...put it through the hole on one side and angle it so it hits the bottom of the bearing on the other side...pound it hard, then hit the top, then the bottom again until it comes out. once one is out you can just go around and pound the other one out.

Who needs bearing extractors?? WE HAVE HAMMERS!!!!

Last edited by Flatland Freak; 10-08-02 at 06:19 PM.
Flatland Freak is offline