View Single Post
Old 10-09-11, 07:05 PM
  #2  
JanMM
rebmeM roineS
 
JanMM's Avatar
 
Join Date: Jan 2006
Location: Metro Indy, IN
Posts: 15,484

Bikes: RANS V3 ti, RANS V-Rex, RANS Screamer

Mentioned: 15 Post(s)
Tagged: 0 Thread(s)
Quoted: 469 Post(s)
Liked 24 Times in 23 Posts
I've used a pipe cutter on aluminum bars to get a straight cut.

These are short riser bars? Those tend to be a bit longer than flat bars.
At any rate, 1/2 to 1 inch off each end is fairly minimal.
Attached Images
__________________
RANS V3 Ti, RANS V-Rex, RANS Screamer
JanMM is online now