View Single Post
Old 10-19-11, 10:06 AM
  #11  
skieslord
Member
 
Join Date: Oct 2011
Posts: 47
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Cobba-
Thanks for you tips.
There are two inch inside each side.
The metal piece was machined few mils wider so it get some pressure to fit.
Yes, we tapped threads and made set scrubs with red loctite.
The screws, according to me, are only holding the bar from moving, there is some pressure put when inserting the metal bar ends, it is very strong.
There is loctite, the screws are around 3/4 long chances of screw to come out are minor.

I suggested the machinist to put some MarineTex on the interior of tube but he said it was not neccesary.

hey thanks again for the info.. I hope I can keep my theeth in place.

Last edited by skieslord; 10-19-11 at 01:32 PM.
skieslord is offline