Old 02-20-12, 04:44 PM
  #2  
Preynmantis
Senior Member
 
Join Date: Jul 2011
Location: Southern Colorado
Posts: 163
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Keep pulling the pad out until fully removed, repeat with the other side.


Use the degreaser to clean the holders. No sense putting it back together dirty.





The pads I bought did not have the notches cut in them to put in the retaining nut, so I had to cut them in. In this case, a good knife with a tanto point was important. Too bad Benchmade stopped making the Tanto Vex. I lined up the pads side by side and marked the new pads with lines where the notch would be cut.





Next I used a pair of dikes to cut the new pad along the lines down to the retaining groove.





I then used the knife to cut along the groove. This is where the tanto point helped out.







To be continued...
Preynmantis is offline