View Single Post
Old 07-18-13, 07:13 PM
  #1  
Spld cyclist 
Senior Member
 
Spld cyclist's Avatar
 
Join Date: Nov 2011
Location: Springfield, MA
Posts: 1,067

Bikes: 2012 Motobecane Fantom CXX, 2012 Motobecane Fantom CX, 1997 Bianchi Nyala, 200? Burley Rock 'n Roll

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Sugino crankset bolt torque?

I have this triple Sugino square taper crankset on a bike. I was recently trying to figure out the source of a creak when I checked to see if the bolts were tight. They felt surprisingly loose, so I snugged them up a little bit. Now I'm wondering about the next step. I would like to torque them correctly, but I've heard that you shouldn't do this repeatedly (i.e. tighten them, ride, then tighten them some more). Should I take them off completely and start over? What torque should I use for these?



This crankset originally came on a 2005 Bianchi Volpe. The only markings are "Sugino" on the front and "C-10" on the back.
Attached Images
File Type: jpg
IMG_3751.jpg (96.3 KB, 72 views)
Spld cyclist is offline