View Single Post
Old 03-28-14, 05:06 PM
  #18  
Canaboo
Senior Member
 
Join Date: Dec 2009
Posts: 410
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 14 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
You can just lay carbon or any other fabric over a mold covered with clear tape and stretch an inner tube strip around it to smooth it. Tape one end of the tube down and stretch it around the circumference of the mold and tape down the other end.
The rubber will peel off cleanly and the finished fender will pop off the clear tape surface.
Canaboo is offline