View Single Post
Old 04-11-14, 05:26 PM
  #3  
FBinNY 
Senior Member
 
Join Date: Apr 2009
Location: New Rochelle, NY
Posts: 36,049

Bikes: too many bikes from 1967 10s (5x2)Frejus to a Sumitomo Ti/Chorus aluminum 10s (10x2), plus one non-susp mtn bike I use as my commuter

Mentioned: 121 Post(s)
Tagged: 1 Thread(s)
Quoted: 4336 Post(s)
Likes: 0
Liked 1 Time in 1 Post
I always prefer to start by adjusting the inner and outer limit screws while shifting by pulling on the wire directly rather than using the lever. Once those are right and I can shift to the outer and innermost rings without overshifting. Then I adjust the cable length (tension) for best trim and shifting.
__________________
FB
Chain-L site

An ounce of diagnosis is worth a pound of cure.

“Never argue with an idiot. He will only bring you down to his level and beat you with experience.”, George Carlin

“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN

WARNING, I'm from New York. Thin skinned people should maintain safe distance.
FBinNY is offline