View Single Post
Old 01-24-16, 06:53 PM
Miele Man
Senior Member
Join Date: Jun 2014
Location: Ontario, Canada
Posts: 4,305

Bikes: iele Latina, Miele Suprema, Miele Uno LS, Miele Miele Beta, MMTB, Bianchi Model Unknown, Fiori Venezia, Fiori Napoli, VeloSport Adamas AX

Mentioned: 12 Post(s)
Tagged: 0 Thread(s)
Quoted: 1170 Post(s)
Liked 738 Times in 513 Posts
Originally Posted by dksix View Post
What bike are you needing these for? The reason I ask it I'm wondering if you have one of those drop bar bikes what have the twist shifters. That's the only reason I could think of to be trying to go from twist to bar end shifters.
A friend had a Canadian Tire dropbar bike that used Revo Shifters. The bar was in three pieces. Left hand piece slid through a stiffener/reinforcing sleeve and over the right hand bar section until a hole in everything lined up. Then a bolt and nut was used to keep the assembly together. This 3 pieces steel bar was the same diameter as a normal steel dropbar. i was wondering if this is what the OP has because if it is the bar end shifters might NOT fit inside the handlebar.

Miele Man is offline