Originally Posted by
bradtx
AdvXtrm, Make sure that the chain is long enough so that a big-big combination won't pull the RD into the wheel's spokes if accidentally selected. Also you may need to adjust the B screw for idler pulley clearance with the larger cog.
Brad
Thanks, I did have to adjust the B-tension. I also finished up installing all new cables at the same time, so complete setup and fine tuning was in order. It all running real nice on the stand. I'll try and get it out for a test ride today and see how it goes, and make any adjustments needed.
Unfortunately I did notice an issue though. With the bike up suspended on the stand, when I spin the rear wheel there is a slight wobble to the wheel, enough to rock the hub/cassette a bit as the wheel turns. Is this a bad hub or something else?