Thread: RACKTIME Addit rear rack hardware
View Single Post
Old 10-30-17 | 09:40 AM
  #14  
Tourist in MSN
Senior Member
15 Anniversary
Community Builder
Active Streak: 30 Days
 
Joined: Aug 2010
Posts: 12,760
Likes: 2,119
From: Madison, WI

Bikes: 1961 Ideor, 1966 Perfekt 3 Speed AB Hub, 1994 Bridgestone MB-6, 2006 Airnimal Joey, 2009 Thorn Sherpa, 2013 Thorn Nomad MkII, 2015 VO Pass Hunter, 2017 Lynskey Backroad, 2017 Raleigh Gran Prix, 1980s Bianchi Mixte on a trainer. Others are now gone.

Originally Posted by cyccommute
It's not that the rack stays are flimsy, it's that they lack adjustability. The round stays on Tubus racks (and some others), can be adjusted forward and back, tilted down, moved in and out, and the tabs can even be turned around so that they can fit on a narrower (or wider) frame.
...
And according to the instructions you can also bend the stays by a limited amount. See lower right side of page one. It states that "the roundstay can be adapted through bending" and includes a small figure.
https://www.racktime.com/fileadmin/u...ime_MA_2.0.pdf
Tourist in MSN is offline  
Reply
0