View Single Post
Old 04-02-18, 05:04 PM
Senior Member
DOS's Avatar
Join Date: Feb 2008
Location: Arlington, VA USA
Posts: 2,107
Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
Quoted: 250 Post(s)
Liked 69 Times in 56 Posts
Look Keo Blade 2 service

Two questions about servicing keo blade pedals.

Do the blades wear out? Mine are going on two years old and use the 16nm blade. I am not pulling my foot out of the pedal just yet but they doen't feel as snug as they ised to?

Can I replace the axle cartridge bearings or would I need to replace the whole axle assembly? My left pedal is spinning kind of rough. I popped the spindle out and squirted some grease into the cartridge, which hleped. But looks like I might need to replace the bearing in the not too terribly distant future. Not sure if I can get the bearing dislodged from the spindle or if need to buy a whole new axpe assemblly (about 40 bucks).

DOS is offline