View Single Post
Old 10-01-18, 08:17 AM
  #1  
wingless
Senior Member
 
wingless's Avatar
 
Join Date: Oct 2017
Location: Florida
Posts: 303

Bikes: 2011 Trek 1.2 + 2016 Trek 1.1 H2

Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 114 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
wingless' Telephone Mount

My work has me on the other side of the country for extended duration assignment, so I purchased a bicycle for usage at that location.

The area is unfamiliar to me, so I've been studying maps and it would be useful to have my telephone mounted on the handlebars for real-time maps.

A reasonably-priced mount was purchased on eBay. It has a spring-loaded jaw, w/ a large locking knob. There is also a compass and white LED lights.

The mount has a ball joint that permits articulation to different attitudes.

During my first ride on a flat surface the ball joint arm snapped at the ball. The vendor provided a refund, permitting me to retain the broken parts.

The mount was redesigned and reworked by me to eliminate the ball joint and arm, by rigidly bonding the parts together. The rework was "easy" requiring two different small-diameter drill bits, two additional small screws, slightly longer than existing screws and a secure Torx driver.

The mount is very nice and would have been great had it not failed. The spring jaw is easy to operate, to place the phone, then to remove the phone. The jaws have soft cushioning rubber to avoid damage to the phone. The large clamp knob may be used to lock the jaw, if desired, but the spring jaw is very secure w/o locking the knob.

The mount is advertised as "aluminum", but the body is plastic. The ball joint knob tightening screw is aluminum, but that is the only part made from that metal.

The disc compass works fine. It must be flat to the ground to work, the rotation stops when not flat to the ground.

The dual white LED lamps have a "large" soft on/off push button switch on the end of the mount. Each switch press cycles the lamp through these states: On; Slow Blink; Fast Blink and Off. There are two CR2032 3V coin cell batteries that are easy to change by removing two Phillips head screws.

The mount is attached to the handlebars w/ secure Torx screws. An angle secure Torx driver is supplied, having a plain rod on the long arm and the correct secure Torx drive on the short arm. It would have been handy to have both ends w/ the correct drive, for fast attachment, followed by proper tightening.

This modified mount now provides the required secure telephone retention during bicycle operation.

Mass: 136g (final modified condition)
Body Dimensions: 6" long x 1" wide x 2" deep
Jaw Dimensions: 2-1/8" to 3"


Modified Configuration


LED Batteries


Original Configuration
wingless is offline