Old 01-06-19, 08:49 PM
  #107  
Choke 
Disciple of St. Tullio
 
Choke's Avatar
 
Join Date: Jul 2008
Location: State of Jefferson
Posts: 458

Bikes: Ciöcc, Bianchi, DeRosa, Eddy Merckx, Frejus, Hampsten, Kondor, Losa, Magni, Pegoretti, Pelizzoli, Pogliaghi, Scapin

Mentioned: 14 Post(s)
Tagged: 0 Thread(s)
Quoted: 125 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by Classtime View Post

Good idea. Enough flex not to fatigue and break? AND enough support? I have no experience with it. Probably 0.125" not the 0.063?
I've never used it in that application so I really can't say for sure. Two pieces attached together to form a knife sheath are pretty solid. I think if I was doing it I would start with a thin layer and go from there, maybe 0.060. If that didn't provide enough support then I would add a 2nd layer and attach them together using sheath rivets or Chicago screws (assuming this will be under an insole). You could even mix thicknesses to fine tune the flex and support.
Choke is offline