View Single Post
Old 01-11-19, 11:51 AM
  #18  
Prowler 
Senior Member
 
Join Date: Nov 2013
Location: Near Pottstown, PA: 30 NW of Philadelphia
Posts: 1,276

Bikes: 2 Trek Mtn, Cannondale R600 road, 6 vintage road bikes

Mentioned: 50 Post(s)
Tagged: 0 Thread(s)
Quoted: 147 Post(s)
Liked 11 Times in 6 Posts
Originally Posted by Prowler View Post
Maybe you could run the temp screw in from the back side so you don't have to cut the head off. I've not looked to see if that cover is threaded right through. I'll bet it though - easier to manufacture.
Bad idea. You could run a temp screw in from the cage end of the cover but the head of the screw would interfere with the cage as it swung around. Scratch this one.
Prowler is offline