View Single Post
Old 09-21-19, 06:49 PM
  #4  
prairiepedaler
Senior Member
 
Join Date: Aug 2016
Location: Jolly 'ol Winnipeg
Posts: 983

Bikes: Raleigh Elkhorn, Maruishi MT18 Frame, Sekine Toledo Frame

Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Liked 98 Times in 62 Posts
Hello Bob and Andy... thank you for the input on the matter. I have the wheel at home now and upon closer inspection this hub uses press fit replaceable bearings. Hmmm. Possibilities may have just opened up. I should (hope to) be able to find a bearing with the same O.D. as the original and an I.D. to match a 10mm replacement axle. This 14mm axle is hollow, yet allows for being nutted on too.
prairiepedaler is offline