View Single Post
Old 11-13-20, 08:20 AM
  #6  
pdlamb
Senior Member
 
Join Date: Dec 2010
Location: northern Deep South
Posts: 6,825

Bikes: Fuji Touring, Novara Randonee

Mentioned: 32 Post(s)
Tagged: 0 Thread(s)
Quoted: 1573 Post(s)
Liked 782 Times in 483 Posts
Originally Posted by Kapusta View Post
Not sure I am following, here. If you cover the holes, you are putting the tape on the bottom of the well. What is the alternate recommendation?
The previous two posts recommended taping "edge to edge." If the wheel is going to be used with tubes, the thickness of the tape may interfere with sliding the bead down to remove and replace the tire.

I'd think that would hold true as well for initial tire installation on a tubeless setup, but perhaps you wouldn't have to fix most flats that way.
pdlamb is offline