View Single Post
Old 02-12-21, 09:22 AM
  #9  
guy153
Senior Member
 
Join Date: Dec 2019
Posts: 559
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 204 Post(s)
Liked 111 Times in 90 Posts
Yes I was going to say this is not much different to a dropout or a fork end. Those paragon dealies look nice but you can also just have a bit of tang on the green bit, insert it into the tube and fill the gaps with bronze. Cutting the round tubes at a bit of an angle. Is a good idea so you can get more bronze in there. Then you can try to sand it to a nice shape.

I've done this a few times with TIG silicon bronze and it works out pretty well.
guy153 is offline