Old 04-26-21, 03:15 PM
  #9  
JaccoW
Overdoing projects
 
JaccoW's Avatar
 
Join Date: Oct 2011
Location: Rotterdam, former republic of the Netherlands
Posts: 2,202

Bikes: Batavus Randonneur GL, Gazelle Orange Excellent, Gazelle Super Licht, Gazelle Grand Tourist, Gazelle Lausanne, Gazelle Tandem, Koga-Miyata SilverAce, Koga-Miyata WorldTraveller

Mentioned: 49 Post(s)
Tagged: 0 Thread(s)
Quoted: 707 Post(s)
Liked 867 Times in 515 Posts
Nice setup @Tourist in MSN. Personally I prefer running the wires inside the frame as much as possible to prevent any risk of snagging and use SON coaxial couplers on all the bits in between. I like running the light inside the rolled edge of the fender as well but recently I ran into an issue where the wheel was rubbing against the fender but I had to continue. The end result was that I actually heated the fender enough that the cable melted inside the rolled edge. Which, as you can imagine, caused a short in the rear light.

Next time I'm trying the glue. Crimping a rolled edge is hard to do invisibly and nearly impossible if you want to paint the fender.
JaccoW is offline