View Single Post
Old 05-08-21, 12:54 AM
  #11  
PimpMan
Senior Member
 
Join Date: Feb 2018
Posts: 75
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 89 Post(s)
Liked 3 Times in 2 Posts
Used all 184mm spokes, nipples screwed in equally just to cover the spoke thread, wheel is almost true, however some spokes go inside rim further than others!

Already tried to tighten them its same story they do not tighten at equal lengths (equal number of turns some spokes not tighten at all while others turn all the way).

Used same spoke length as this wheel was built with before i taken it apart and i put new hub that is exactly the same as old one.

This rim is very bad design - it has sharp inner wall and nipple hole is about 4mm thick so nipple fixed at 90 degree angle from the rim.













Last edited by PimpMan; 05-08-21 at 01:12 AM.
PimpMan is offline