View Single Post
Old 06-20-21, 03:04 PM
Senior Member
Monoborracho's Avatar
Join Date: Dec 2005
Location: Small town America with lots of good roads
Posts: 2,706

Bikes: More than I really should own.

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 188 Post(s)
Liked 12 Times in 10 Posts
Originally Posted by himespau View Post
Is it a spacer to run a 9/10 speed cassette on a hub meant for 11 speed?
I it might be.
My initial thoughts were something like that but a 4.5mm is required for 7 speed on an 8-9-10 freehub. At about 1.85mm, as measured by micrometer, it is almost same as a single 10 speed cog. At those sizes my micrometer will give a slightly different reading every time I check.

I didn't really think about the 9/10 to 11 hub you mentioned but then my busiest wheel is only 10 speed.

Monoborracho is offline  
Likes For Monoborracho: